my new/first cj7 project...

[carchameleon]

thanks, let me know how much you want for that hard top, just b/c i\'m planning on driving it a little during the winter... just enough...

last night i figured out what my 33\'s are good for...

its not letting me upload pics, will do later

[carchameleon]

that was fun... going to try again with more tires tomorrow...  :-D

[gCracker]

I better not see my tires stacked there!!

[carchameleon]

your no fun, it won\'t hurt them :)

[smichaelR22]

you can borrow a 42\" anytime    :)

[MrMindless]

now you can figure out shock mounting, right?

[carchameleon]

have to run fuel lines...
rear shock mounting
figure out 2nd 3-speed
get lockers/1piece axles
few other misc things

also a few things on the trailer

[carchameleon]

add ignition cylinder to the list...

have it apart and the new part, also now have the special tools to take the column apart...

no idea how to get the actual cylinder out, its apart to that point, but the cylinder won\'t come out, bah

heres what i see:

[Ryan_25]

http://www.epiccomputer.com/dale/jeepjunk/tilt/tilt.html

Here is a link

[carchameleon]

figured it out, have to punch through to get to the spring...

thats irritating, but its back from that to normal in about 1/2 hour

amaizing what the right tools, and knowing what the hell your doing does...

[carchameleon]

this is not the best angle for my cj but its cool my cj is on a website... from the lancaster... i mean dunn tire raceway cruise night we went to
http://www.rodandpiston.com/picview.asp?id=cruise/sandr08-week11&n=102


also found a cj5 in michigan that i might buy and swap parts... make mine lots more capable...

[MrMindless]

donor parts from an already built running jeep seems like a poor idea.

[carchameleon]

its gone anyways....

[carchameleon]

got to smike\'s last night, and realized my u-bolts were a little loose and the broken bottom leaf on the driver rear partially fell out...   i pulled the other half out and tightened all the u-bolts, looks like i\'m going to use those add a leafs after all.    also planning on dropping the tank, possibly get a  new tank and i will be running new lines and getting a new fillerneck.

[carchameleon]

got my front aussie in tonight, with a little help.  now i just have to put the rest of the axle together, and start on the rear...
the gas tank is on the floor, tank looks good, got a new sender, i\'m going to run rubber fuel line.  i\'ll put a couple of pics up soon

by the way, i put 1 add a leaf in to replace the broken one (and to compare before i put the rest of them in).  the ride height is 1/8th of an inch lower than the non add a leaf, interesting...