http://www.aussielocker.com
Driveshafts

Author Topic: Driveshafts  (Read 2664 times)

Offline 18436572

  • Board Member
  • Newbie
  • ****
  • Posts: 19
Driveshafts
« on: June 04, 2020, 01:14:01 PM »
Looking to do a spare/new driveshaft for rear.  Is anyone running the double Cardan joint or do you do away with them?

Also best place to have one done?
Joe Bailey

80s Turbo diesel Samurai, Toyota drive line, 37” red labels

92 k1500, 383 stroker, 5 spd manual.

Offline MrMindless

  • Administrator
  • Hero Member
  • *****
  • Posts: 3453
Re: Driveshafts
« Reply #1 on: June 04, 2020, 01:28:31 PM »
not fleet pride.

shaft design is a function of design constraints and angles, double cardan is for when all the angle is at the tcase, and you're running within about 3Ëš of 0 angle (minimum 1Ëš) from pinion to shaft.

single joints are for when pinion angle to shaft and case angle to shaft match, in either direction (4Ëš down from case to shaft and 4Ëš up from shaft to pinion, or down and then down)
Michael Maskalans
#571 Last Minute Motorsports
High Miler: 07.5 Ram 6.7 6sp 4x2, ARB, 19.5s
2003 R'Audi Allroad 6sp
Road Block: 98 Dakota 203/205 triple stick, 42" SXs
Dumpbus: 97 Ram 24v P-pumped, RoadRanger 13sp
'87 AMC Eagle Wagon

 

test block /modules/smf/index.php?topic=3945.msg31909