http://www.m4wdfabrications.com/
need metal stock...
« previous next »
Pages: [1]   Go Down

Author Topic: need metal stock...  (Read 4261 times)

Offline rejeep

  • Hero Member
  • *****
  • Posts: 629
need metal stock...
« on: June 04, 2009, 10:11:34 PM »
I need a few feet of rectangle tube.. 2x1  not structural so whatever..
Any suggestions?
Logged

Offline smichaelR22

  • Club Member
  • Hero Member
  • ***
  • Posts: 4344
Re: need metal stock...
« Reply #1 on: June 05, 2009, 06:28:43 AM »
bring Ryan a case of beer or make a stop at Rochester surplus, im sure either would have what your looking for.

20$ minimum i think may still be in effect at surplus on Lyell ave.  it was 66 cents a lb last time i bought 220lbs of steel
Logged
572 single seat race buggy
573 Brolite '97 Ranger, '96 backup ranger
1997 ZJ 35's
2014 Ram 4500 Cummins 6 speed 4x4
48' enclosed trailer

Offline MrMindless

  • Administrator
  • Hero Member
  • *****
  • Posts: 3453
Re: need metal stock...
« Reply #2 on: June 05, 2009, 09:35:57 AM »
yeah Rochester Surplus always has the minimum.
Logged
Michael Maskalans
#571 Last Minute Motorsports
High Miler: 07.5 Ram 6.7 6sp 4x2, ARB, 19.5s
2003 R'Audi Allroad 6sp
Road Block: 98 Dakota 203/205 triple stick, 42" SXs
Dumpbus: 97 Ram 24v P-pumped, RoadRanger 13sp
'87 AMC Eagle Wagon

Offline Ryan_25

  • Hero Member
  • *****
  • Posts: 703
Re: need metal stock...
« Reply #3 on: June 05, 2009, 10:41:33 AM »
I dont have any 1x2. I have 2x2 1x3 and some round stuff.
Logged

Offline rejeep

  • Hero Member
  • *****
  • Posts: 629
Re: need metal stock...
« Reply #4 on: June 07, 2009, 07:10:15 AM »
i swung by metal supermarket after i dropped my wife off at the airport..
they had exactly what I wanted..
2x2.25 and did all the cutting for me... no minimum
Logged
Pages: [1]   Go Up
« previous next »
 
©Team Mudnuts 4x4 Club, Inc. DBA Fingerlakes 4x4 All materials on this site may not be reproduced without permission.

XOOPS Template created with IXThemes

test block /modules/smf/index.php?topic=1222.0;prev_next=next