Fingerlakes 4X4 Forum

TECHNICAL FORUMS => General Tech => Topic started by: bear555 on February 10, 2011, 10:00:30 PM

Title: U Joint smoked
Post by: bear555 on February 10, 2011, 10:00:30 PM

Does this look bad :)

So that annoying vibration turned into a banging. So this is whats left of my transfer case U-Joint on my rear drive shaft
Hopefully the shaft yoke is not too damaged that it wont take a new U-joint.

Title: Re: U Joint smoked
Post by: rejeep on February 11, 2011, 07:48:59 AM

i would worry about balance if you can get a new joint in there..

Title: Re: U Joint smoked
Post by: Wingman on February 11, 2011, 08:35:32 AM

Nice job!

Title: Re: U Joint smoked
Post by: bear555 on February 11, 2011, 07:11:51 PM

I know its my fault for not getting after it earlier, but it was TOO COLD!. The yoke is pretty banged up. I don\'t know if it will take a new joint but I\'ll find out.