PUBLIC FORUMS => General Discussion => Topic started by: MrMindless on October 27, 2009, 04:20:08 AM
Title: machining services needed
Post by: MrMindless on October 27, 2009, 04:20:08 AM
I got a set of 19.5s for my dually, I need to get the center bores opened up from ~4.5\" to ~4.75\" (tape measure accuracy). These are hub-centric so it actually matters.
Anyone have any recommendations?
Even better if they happen to offer a reasonable rate on blasting them for me too, otherwise I have a few quality hours with a wire wheel in my near future too.
Title: Re: machining services needed
Post by: matt on November 06, 2009, 12:00:36 PM
Are the tires on them? I may be able to spin the centers out on them. pm me or call me.
Title: Re: machining services needed
Post by: MrMindless on November 07, 2009, 06:08:14 AM
I had Vic at OEM take care of them. picking them up early next week.
Title: Re: machining services needed
Post by: Joe on December 16, 2009, 06:00:59 PM
I saw the video on youtube, pretty sweet. Vic\'s got a damn nice shop going there. I just wish I lived a little closer to it. I\'ve got a decent list of work for him.
Title: Re: machining services needed
Post by: MrMindless on December 17, 2009, 01:04:23 PM
Me too! It\'s almost an hour from the Henrietta area to his shop.
